remove 'other' category

_config.yml

@@ -76,8 +76,3 @@ collections:
     caption: Whisper
     sidebar_index: 9
     frontpage: _whisper/Whisper-Overview.md
-  doc:
-    output: true
-    permalink: docs/:collection/:slug
-    caption: Other
-    sidebar_index: 9

docs/_legacy/Gas-Price-Oracle.md

@@ -0,0 +1,44 @@
+---
+title: Gas price oracle
+---
+
+The gas price oracle is a helper function of the Geth client that tries to find an
+appropriate default gas price when sending transactions. It can be parametrized with the
+following command line options:
+
+- `gpomin`: lower limit of suggested gas price. This should be set at least as high as the
+  `gasprice` setting usually used by miners so that your transactions will not be rejected
+  automatically because of a too low price.
+
+- `gpomax`: higher limit of suggested gas price. During load peaks when there is a
+  competition between transactions to get into the blocks, the price needs to be limited,
+  otherwise the oracle would eventually try to overbid everyone else at any price.
+
+- `gpofull`: a block is considered "full" when a certain percentage of the block gas limit
+  (specified in percents) is used up by transactions. If a block is not "full", that means
+  that a transaction could have been accepted even with a minimal price offered.
+
+- `gpobasedown`: an exponential ratio (specified in `1/1000ths`) by which the base price
+  decreases when the lowest acceptable price of the last block is below the last base
+  price.
+
+- `gpobaseup`: an exponential ratio (specified in `1/1000ths`) by which the base price
+  increases when the lowest acceptable price of the last block is over the last base
+  price.
+
+- `gpobasecf`: a correction factor (specified in percents) of the base price. The
+  suggested price is the corrected base price, limited by `gpomin` and `gpomax`.
+
+The lowest acceptable price is defined as a price that could have been enough to insert a
+transaction into a certain block. Although this value varies slightly with the gas used by
+the particular transaction, it is aproximated as follows: if the block is full, it is the
+lowest transaction gas price found in that block. If the block is not full, it equals to
+gpomin.
+
+The base price is a moving value that is adjusted from block to block, up if it was lower
+than the lowest acceptable price, down otherwise. Note that there is a slight amount of
+randomness added to the correction factors so that your client will not behave absolutely
+predictable on the market.
+
+If you want to specify a constant for the default gas price and not use the oracle, set
+both `gpomin` and `gpomax` to the same value.

docs/_legacy/sending-ether.md

@@ -0,0 +1,33 @@
+---
+title: Sending ether
+---
+
+The basic way of sending a simple transaction of ether with the console is as follows:
+```js
+> eth.sendTransaction({from:sender, to:receiver, value: amount})
+```
+
+Using the built-in JavaScript, you can easily set variables to hold these values. For example:
+
+```js
+> var sender = eth.accounts[0];
+> var receiver = eth.accounts[1];
+> var amount = web3.toWei(0.01, "ether")
+```
+
+Alternatively, you can compose a transaction in a single line with:
+
+```js
+> eth.sendTransaction({from:eth.coinbase, to:eth.accounts[1], value: web3.toWei(0.05, "ether")})
+Please unlock account d1ade25ccd3d550a7eb532ac759cac7be09c2719.
+Passphrase: 
+Account is now unlocked for this session.
+'0xeeb66b211e7d9be55232ed70c2ebb1bcc5d5fd9ed01d876fac5cff45b5bf8bf4'
+```
+
+The resulting transaction is `0xeeb66b211e7d9be55232ed70c2ebb1bcc5d5fd9ed01d876fac5cff45b5bf8bf4`
+
+If the password was incorrect you will instead receive an error:
+```js
+error: could not unlock sender account
+```